Welcome to the Worldwide V8 Bikers Forum

I lost one of the two cross pins (the ones that the brake pads float on) on the rear caliper of my 04 SB bike. Was able to temporarily replace it with an aircraft #10 x 2" bolt and lock nut and continue to ride.

Anyone know where to buy Brembo replacement parts?

Mark -

Try here, you may have to pull one of the stock slider pins to measure ...

http://www.oppracing.com/category/231-b ... ent-parts/

Here are bolt replcements too ...

http://www.oppracing.com/category/937-b ... ers-bolts/

These guys have everything Brembo to rebuild ...

Good luck,

Don

Don,

Thanks!

That is what I as looking for.

Mark -

Your welcome, any idea how the pin came out? Had you replaced pads or other brake work recently?

Don

I have my complete caliper that I removed to do the upgrade in the garage. Want me to send it to you? It is doing me no good sitting on the shelf.

V-MAN wrote:Mark -

Your welcome, any idea how the pin came out? Had you replaced pads or other brake work recently?

Don

Don,

No brake work per se, but I did recently put on new tires which obviously involved removing the brake caliper. Did not remove the brake pads or pins.

My guess is one of the hair pin clips got bumped in the process. Kind of hard to do though as they are tucked away in there.

Bottom line is will never know but, that is sure something to double check on reassembly.

Appreciate your help!

petitemoose wrote:I have my complete caliper that I removed to do the upgrade in the garage. Want me to send it to you? It is doing me no good sitting on the shelf.

Dennis,

Sure; that is very generous of you.

Now I owe you a couple of trips to the desert bar.

New address:

Mark Maupin
306 McKendree Ct
Bethlehem, GA 30620

Will get it mailed out to you today