Welcome to the Worldwide V8 Bikers Forum

I just installed a new TCI torque converter and of course after reassembling the bike the torque converter seal was leaking. I split the bike again and pulled the trans pump off and pressed in a new seal (also replacing both O-rings in and on the pump). I'm ready to bolt the pump back on but don't know how tight the 4 5/16 bolts should be? Anyone have the torque specs or can point me in the right direction to find them?
Thanks,
George

George -

I am sure you already having your bike back together ... if not here is a chart showing general guidelines. Looks like 10-29 ftlb depending on grade of bolt.